Sideboard – bottom web frame

You could almost picture some drawers…

IMG_5123

The bottom web frame uses similar construction to the top web frame. It differs in how it connects to the case sides. While the top web frame is dovetailed (half-blind) into the top of the side, the bottom web frame is joined with dados. If you have downloaded the Sketchup model for this project, you can see there is a dado on the front and back of the case side to receive the front and back pieces of the web frame. That dado is not continuous across the width of the side pieces. I forgot to take a photo before I glued it up.

IMG_5129

The rest of the frame is similar construction to the top web frame where the ends and middle of the web frame are allowed to float within the web frame to allow for wood movement. I repeated this same process of only gluing in the front mortise and tenons and leaving the back free floating (with-out glue).

The middle divider in the bottom web frame matches the construction of the top web frame. These will eventually be connected with a “divider” piece at the front and back of the case, which will further define the drawer locations. There will also be a runner that “runs” front to back on that middle divider that will help guide both drawers into and out of the case.

IMG_5128

IMG_5127

-that blue painters tape helps me to remember where each joint goes during glue-up – it can get confusing when your running around like a mad-man while the glue is drying

Next up should be the dividers that define the drawer and door locations.

-JR

Advertisements